Practical Guide for Operating Your Waste Tire Cutter

Following the correct operating procedures is key to maintaining your waste tire cutter and avoiding unnecessary breakdowns. Many common issues arise simply because basic guidelines are not followed. Here are four essential tips to keep your machine running smoothly and safely.

1. Regularly Lubricate the Bearings

Always check and grease the bearings during operation. If bearings run dry for too long, they will overheat and fail. Make it a habit to inspect them regularly. Remember: if the machine stops due to a problem, only restart it after the issue has been completely resolved.

2. Check Rotation Direction for New Machines

When starting a new machine, always verify the rotation direction. The cutter should rotate according to the arrow marked on the equipment. Incorrect rotation will prevent proper material discharge and may cause the drive belt to slip off.

3. Inspect and Replace Wear Parts Frequently

Regularly check vulnerable components and replace them in time to ensure uninterrupted production. Worn parts not only reduce efficiency but can also lead to further damage if ignored.

4. Maintain Blades Properly

Monitor blade wear closely. If you notice lower output or larger rubber chunks, remove the blades for sharpening. When reinstalling, make sure the blades are mounted in the correct direction. Incorrect installation will significantly reduce cutting efficiency.

By keeping these points in mind, you can extend your machine’s service life, maintain productivity, and create a safer working environment. Good habits prevent most operational problems.